CT-460: PA24481A01_04
Page: 1 of 4
6-2018
CT-460
PA24481A01
Rev. 04 6-2018
© Panduit Corp. 2018
NEW TOOLS – BEFORE PLACING INTO SERVICE
1. VISUALLY INSPECT TOOL
FOR DAMAGE.
All Panduit crimping tools are calibrated and inspected before they are shipped from
the factory. There is, however, a possibility of damage in shipment. All new tools
should therefore be inspected before being used.
2. CHECK DIE CLOSURE
3. CLEAN EXCESS OIL FROM
CRIMP DIES AND USE.
New tools are shipped factory lubricated. They do not require extensive cleaning.
After inspection, simply clean any excess oil from the crimping dies and place into
service.
CAUTION: Verify power is “OFF” before
working on wiring with this tool. The plastic grips
are for the user’s comfort—and are not intended
to insulate against shock while working on live
electrical circuits.
WARNING: Controlled cycle device prevents tool from opening before cycle is
completed. Keep hands and other objects clear of pinch areas before closing.
ATTENTION: TO DISENGAGE CONTROLLED CYCLE DEVICE:
Turn the ratchet release screw counterclockwise and open handles.
The controlled cycle device will automatically reset after screw is released.
Email:
EU Website:
EU Email:
Emeatoolservicecenter
@panduit.com
www.panduit.com
Technical Support:
1-800-777-3300
Panduit Europe • EMEA Headquarters
Tel: +31 (0) 546 580 452 • Fax: +31 (0) 546 580 441
CRIMP DIES for
Pan-Term
insulated
terminals, splices
and wire joints.
Lock Screw
Notch
Ratchet Release
Screw
Locator Retention
Screw
BACK
VIEW
(FIG. 1)
FRONT
VIEW
(FIG. 2)
Adjustment
Pin
Terminal Locator
