Panduit ATLONA AT-UHD-CLSO-601, Application Programming Interface

Page: 23 / 33

AT-UHD-CLSO-601 23
Commands
ProjSWMode
Sets the projector lamp cool-down timer, in seconds. This value specifies the time interval that must elapse, after the
display control “off” command is sent, before the display “power on” command can be sent. This command is used
to prevent the projector from missing a “power on” command while the lamps are cooling. Use the sta argument to
display the current setting.
Syntax
ProjSWMode X
Parameter Description Range
X Time interval 0 ... 300, sta
Example
ProjSWMode 120
Feedback
ProjSWMode 120
ProjWarmUpT
Sets the projector lamp warm-up timer, in seconds. During the warm-up interval, the unit will not start the auto
power-off timer. This value specifies the time interval that must elapse, after the display control “on” command
is sent, before the display “power off” command can be sent. This command is used to prevent a “power off”
command from being sent while the lamps are warming up. Specify the sta argument, in place of the time interval, to
return the current setting.
Syntax
ProjWarmUpT X
Parameter Description Range
X Time interval 0 ... 300, sta
Example
ProjWarmUpT 120
Feedback
ProjSWMode 120
PWOFF
This command will place the AT-UHD-CLSO-601 in a “power-off” (standby) state When the unit is in the “off” state,
the PWR LED indicator will glow solid red and no video will pass from the transmitter to the receiver.
Syntax
PWOFF
Example
PWOFF
Feedback
PWOFF
This command does not require any parameters