AT-UHD-CAT-8
30
Advanced Operation
Powering Sinks and the AT-UHD-CAT-8
In this mode, the
POWER
button will power-on / power-off the unit and the connected displays. CEC* power-on /
power-off commands are transmitted over all
HDBaseT OUT
ports.
1.
Make the proper connections by following steps 1 through 4, under
Powering Sink Devices (page 28)
.
2. Click the
Power button mode
drop-down list and select
Both
.
3.
Test the CEC power-on and power-off commands for the display (sink) device by pressing the
ON
and
OFF
buttons, near the bottom of the page.
4.
Press the
POWER
button on the front panel to power-on or power-off both the display and AT-UHD-CAT-8.
*Consumer Electronics Control (
CEC): Atlona has confirmed proper CEC functionality with several current models of Samsung, Panasonic, and
Sony displays. However, it is not guaranteed that CEC will work with all displays. Many manufacturers do not support the CEC “off” command,
and older displays use proprietary commands. Atlona only supports displays that use the CEC command structure defined in HDMI 1.2a. It is
recommended that dealers request an evaluation product from Atlona, before designing a system using the CEC protocol. If this is not possible,
then other control methods will need to be considered, in order to control displays using Atlona products.