AT-JUNO-451
13
Installation
• Setting DHCP mode
1. Connect to the AT-JUNO-451 using RS-232 or Telnet.
2. At the command line, execute the
IPDHCP
command using the
on
argument, as shown. All characters are
case-sensitive.
IPDHCP on
Once DHCP is enabled, the unit will be assigned an IP address by the DHCP server (if present).
, in the web GUI, allows the AT-JUNO-451 to use either DHCP or static IP mode.
In order to access the web GUI, the IP address of the AT-JUNO-451 must be known. Refer to
.
1. Open the desired web browser and enter the IP address of the AT-JUNO-451.
2.
Log in, using the required credentials. The factory-default username and password are listed below:
Username:
root
Password:
Atlona
3. Click the
System
tab.
4. Click the
IP Mode
toggle to switch between the
DHCP
and
STATIC IP
setting. When set to
STATIC IP
, the
IP
,
Netmask
, and
Gateway
fields can be modified.
5. Click the
Save
button to save the changes.
Setting the IP Address using the Web GUI
Displaying the IP Address
Press and hold the
INPUT
button on the front panel for 10 seconds, to display the IP address of the AT-JUNO-451, in
the upper-left corner of the connected display.
