AT-HDVS-SC-RX
21
The Web GUI
Video page
Prefer Timing
Click this drop-down list to select the desired input resolution.
HDCP Settings
HDCP can be controlled on each input. Set this toggle switch to the
ON
position to set the HDCP reporting mode
of each input (
HDMI IN
,
HDBaseT
). Some devices will automatically send HDCP content if an HDCP-compliant
display is detected. Setting this toggle switch to the
OFF
position, will force the device to ignore detection of HDCP-
compliant displays, allowing non-HDCP content to be transmitted from the souce. Note that setting this feature to
the
OFF
position does
not
decrypt HDCP content.
Auto Switch
• Click the
Auto Switch mode
to the
ON
position to enable auto-switching. If the AT-HDVS-SC-RX detects a
signal loss at one of the inputs, then it will automatically switch to the opposite input. Set to the OFF position to
disable auto-switching.
• Click the
Fallback Time
drop-down list to select the fallback time interval. The AT-HDVS-SC-TX will wait until
the fallback timer expires before auto-switching to the other input. Range: 3 - 600 seconds.
Available
Resolutions
Native
1280x720
1440x900
1920x1200
800x600
1280x800
1600x900
2560x1440
1024x768
1366x768
1920x1080
3840x2160
NOTE:
When setting the fallback time interval, make sure that the Auto Power Off timer is at least
six seconds longer that the fallback time interval. Refer to the
for more
information.