AT-HDVS-200-TX / AT-HDVS-200-TX-PSK
10
Installation
The AT-HDVS-200-TX provides RS-232 control between an automation system and an RS-232 device. This step is
optional.
1.
Use wire strippers to remove a portion of the cable jacket.
2.
Remove at least 3/16” (5 mm) from the insulation of the RX, TX, and GND wires.
3.
Insert the TX, RX, and GND wires into correct terminal on the included Phoenix block. If using non-tinned
stranded wire, presss the orange tab, above the terminal, while inserting the exposed wire. Repeat this step for
the TX, RX, and GND connections.
RS-232 Connector
GND
RX
TX
AT-HDVS-200-TX / AT-HDVS-200-TX-PSK
1.
Connect an HDMI cable between the HD source and the
HDMI IN 1
port on the switcher.
2.
Connect another HDMI cable between another HD source and the
HDMI IN 2
port on the switcher.
3.
Connect a VGA cable from a VGA source to the
VGA IN
port on the switcher.
4.
Connect a 3.5 mm mini-stereo cable from the
AUDIO IN
port on the switcher to the analog audio source.
The AT-HDVS-200-TX can pass audio either with or without a video signal. Refer to the
Audio Freerun Status
option under the
5.
Connect an Ethernet cable, up to 330 feet (100 meters), from the
LAN
port on the switcher to a Local Area
Network (LAN). Refer to the
for information on switching between DHCP and static IP
modes.
6.
Connect an Ethernet cable, up to 230 feet (70 meters), from the
HDBaseT OUT
port on the switcher to
a PoE-compatible transmitter (not included). Ethernet cables should use EIA/TIA-568B termination.
7.
OPTIONAL: Connect an RS-232 control device to the
RS-232
port on the switcher. This port is used to control
functions of the AT-HDVS-200-TX, such as volume up/down, display on/off, etc.
No power supply is required for the AT-HDVS-200-TX. This unit will be powered over the Ethernet cable, from an
HDBaseT receiver.
IMPORTANT
: I
f EZ RJ-45 connectors are being used to terminate Ethernet cable, make sure that
each twisted pair does not extend beyond the RJ-45 connector. Exposed twisted-pair wires may
cause a short when connected to the
LAN
port.
Connection Instructions
