Panduit ATLONA AT-HDR-CAT-2, Manual

Page: 8 / 54

AT-HDR-CAT-2 8
DC 48V LAN HDMI AUDIO OUT
IN OUT
IR RS-232
RX TX RX TX
MASTER
1 2
HDBaseT OUT
RX RX TX TX
RS-232 IR
R L
1
2
FW EDID
AT-HDR-CAT-2
POWER
INT LOCK 2 1 OUT IN
HDMI
LEARN
HDBaseT
DC 48V LAN HDMI AUDIO OUT
IN OUT
IR RS-232
RX TX RX TX
MASTER
1 2
HDBaseT OUT
RX RX TX TX
RS-232 IR
R L
1
2
FW EDID
AT-HDR-CAT-2
POWER
INT LOCK 2 1 OUT IN
HDMI
LEARN
HDBaseT
1 HDMI Indicators
Displays the status of the HDMI IN and HDMI OUT
ports. When connected to a source or display (sink)
device, respectively, the LED indicator will be blue.
2 HDBaseT Indicators
Displays the status of the HDBaseT OUT ports.
When connected to an HDBaseT receiver, with an
active sink, the LED indicator will be blue. If no active
sink is connected, or the sink is powered off, then the
indicator will not be illuminated.
3 Lock
This LED will be blue when the unit is locked.
4 POWER
Press this button to power-on or place the unit into
standby mode.
5 INT
This LED indicator will be blue when the unit is using
an internal EDID.
6 LEARN
This LED indicator will flash when a downstream
EDID is being read into memory.
7 EDID
Press this button to switch between the internal (INT)
and learned (LEARN) EDID modes.
8 FW
Connect a USB Type-A to USB-C cable from this
port, to a computer, to update the firmware. Refer
to Updating the Firmware (page 48) for more
information.
9 RS-232 / IR (MASTER)
Connect a control system or other DTE device to this
port to control the AT-HDR-CAT-2.
10 AUDIO OUT
Connect the included 5-pin captive screw connector
to this port and connect it to an audio amplifer, such
as an AT-GAIN-60. Refer to Controlling Audio Output
(page 22) .
11 HDMI IN
Connect an HDMI cable from this port to a source
device.
12 HDMI OUT
Connect an HDMI cable from this port to an HDMI
input on a local display or an additional AT-HDR-
CAT-2 unit.
13 LAN
Connect an Ethernet cable from this port to the
network.
14 HDBaseT OUT
Connect Ethernet cables from these ports to PoE-
compatible receivers.
15 RS-232/IR 1 / 2
Connect a control system or other DTE device to
these ports for pass-through zone control. Each of
these ports uses the associated HDBaseT OUT port.
This allows RS-232 command data to be sent to a
display (sink) device connected to a PoE-comptible
receiver.
16 DC 48V
Connect the included power supply to this power
receptacle.
Panel Description
14 9 10 11 12 13 16 15
1 2 3 4 5 6 7 8