4
1) STANDARD GAS RINGS
The scheme indicating the gas ring, which is controlled
by the knob, is specified on the cooktop surface above
each control knob.
When tap of gas network or gas
cylinder is opened, ignite gas rings performing actions,
which will be described below
:
- Automatic Electrical Ignition
Press and turn the control knob counterclockwise
corresponding to the gas ring, which is planned to be
used, until the
knob is in “Maximum” position (high
flame, Fig. 1). Then press the knob to stop.
- Ignition of Gas Rings Equipped with Control
Thermocouple
If gas rings are equipped with control thermocouple,
then turn the control knob counterclockwise
corresponding to the gas ring, which is planned to be
used, until the knob is in “Maximum” position (high
flame, Fig. 1) and press it, when it comes to stop.
When gas ring ignites, hold the control knob within
about 10 second.
If flame goes out suddenly, turn off the gas ring by the
control knob and wait within at least 1 minute, then try
to turn on the gas ring.
Gas Ring Use
To achieve the maximum result at minimum gas
consumption, you should remember that:
- It is necessary to use pans corresponding to each
gas ring (refer to the Table below and Fig. 2).
- Upon achievement of the boiling point, place the
control knob into “Minimum” position (low flame,
Fig. 1).
- Use only pans with covers.
DUAL gas ring:
regulation of internal flame line independent from
external line (in practice, dual gas ring, which is
controlled by one knob); high flexibility during
operation due to the possibility to use only internal
flame line or the whole gas ring (internal and external
flame lines simultaneously).
IGNITION AND OPERATION OF DUAL GAS RING
Place the pan on the cooktop before igniting the
gas ring.
Notwithstanding that DUAL gas ring is controlled by
the rotary knob, it can be operated in two different
modes.
A)
– Operation of the whole gas ring:
in “off” position
●
it is necessary to press the rotary
control
knob
simultaneously
turning
it
counterclockwise until it gets into the position
designated with a sign of maximum supply position
that will ensure maximum supply for both flame lines.
When the flame ignites, hold the rotary control knob in
pressed position within several seconds until the
device can automatically sustain gas ring ignition.
Then it will be possible to regulate flame intensity
turning the rotary control knob counterclockwise (from
the position of maximum supply for internal and
external flame lines) to the position of maximum supply
for internal line and minimum supply for external line.
In order to go out the gas ring turn the rotary control
knob clockwise, until it gets into “off” position indicated
with sign
●
.
B)
– Operation only with internal flame line:
When flame is ignited, with maximum supply for
internal flame line and minimum supply for external
flame line as it was mentioned above, turn the rotary
control knob counterclockwise until it overcomes a
small obstacle, then supply to the internal line will be
maximum, and external line goes out.
To set the minimum supply to internal flame line,
continue turn the control knob counterclockwise.
Turning off:
In order to go out the gas ring turn the rotary control
knob clockwise, until it gets into “off” position indicated
with sign
●
.
If DUAL gas ring has already operated in one of the
above mentioned modes, you can go from one mode
into the other pressing and turning the control knob
until it gets into the required position.
OFF
MAX EXTERNAL
MAX INTERNAL
MIN
INTERNAL
MIN EXTERNAL
MAX INTERNAL
MAX INTERNAL
OPERATION
