User Manual For CYCLONE
FX
Programmers
31
5.2.3.2.3 Enable/Disable Dynamic IP
Allows the user to toggle the Cyclone configuration between utilizing a Static IP address or a
Dynamic IP address. The user must reset the
CYCLONE
FX
after changing from Static to
Dynamic or vice-versa. The reset button on the front side of the unit may be used.
5.2.3.3
Configure Time Settings (Cyclone Time / Real Time Clock)
The
CYCLONE
FX
is equipped with a Real Time Clock (RTC) module designed to keep accurate
timing even when the Cyclone is turned off. The Date & Time are displayed on the home screen.
This menu presents options that allow the user to configure the Cyclone’s various date/time/
timezone settings, including formatting options.
5.2.3.3.1 Modify Date / Time
1.
Update Time from Internet
- Connects to an SNTP server, fetches the current time, and
saves it to the Cyclone. When executed it displays a
message that this can freeze the Cyclone for up to 3
minutes – This is due to an invalid ARP response due to a
bad gateway configuration. Proper configuration will
ensure the problem is resolved. If the network connection
is not configured/connected this displays a message that
the time failed to update. If it is successful no message is
displayed.
2.
Set Time Zone
Hours
- Allows you to set the timezone offset, in hours +/-, from GMT
time
3.
Set Time Zone
Minutes
- Allows you to set the timezone offset, in m/-, from
GMT time
5.2.3.3.2 Set Time-Date Display
Allows you set the Cyclone’s Time-Date Display to one of the following configurations:
1. Display Date Only
2. Display Time Only
3. Display Date and Time
5.2.3.3.3 Set Date Formatting
Allows you to select how the date is displayed. The options are:
1. YYYY-MM-DD
2. MM-DD-YYYY
3. DD-MM-YYYY
4. MM/DD/YYYY
5.2.3.3.4 Set Time Formatting
Allows you to select how the time is displayed. The options are:
1. HH:MM (24-hour)
2. HH:MM (AM/PM)
3. HH:MM:SS (24-hour)
4. HH:MM:SS (AM/PM)
5.2.3.4
Configure AUX Button
Allows the user to configure an auxiliary (AUX) button which (if configured) will be labeled
appropriately and displayed to the left of the Menu button on the Cyclone’s touchscreen LCD.
When pressed, the AUX button will perform the task for which it has been configured. The options
