TRK-MPC5604P EVB User Manual
11
4.3
Software Setup
4.3.1
Installing CodeWarrior Development Studio
To install the CodeWarrior Development Studio, follow the instructions on the
DVD-ROM.
4.3.2
Installing P&E Resources
Use the TRK-MPC5604P Resources in the DVD-ROM to access and install
P&E resources for the DEMO board. These materials are not required for
operation. The TRK-MPC5604P Resources CD-ROM contains the following
support materials:
•
TRK-MPC5604P User Manual (this document)
•
TRK-MPC5604P Board Schematic
•
TRK-MPC5604P Component Breakdown List
•
P&E Evaluation Software
•
Links to Freescale documentation, P&E Discussion Forums, and
TRK-MPC5604P FAQs.
4.4
Quick Startup
Only a few steps are required to get the TRK-MPC5604P up and running.
Please reference the Quick Start Guide.
4.5
Hardware Setup
4.5.1
First-Time Connection
The TRK-MPC5604P may be connected to a PC through a USB port.
Connection steps are listed below in typical order:
1. Install the required software, as described in the previous section.
2. Make sure the jumper USB_5V for POWER_SELECT is installed.
3. Plug the USB cable A-M connector into a free USB port of the PC.
4. Plug the USB cable B-M connector into the USB connector on the
TRK-MPC5604P Board.
5. The operating system will recognize the Embedded OSJTAG circuitry