User Manual For Cyclone LC Programmers
139
Where:
[old_SAP_path]
The relative or full path to the SAP file. Usually has the .SAP file
extension.
[new_SAP_path]
Optional parameter where the user can specify a relative or full path to
dump the output of the conversion. If path and file name matches the
input, then the output file will replace the input file. If this parameter is not
specified, the output will be dumped in the same path as the input file
renamed with postfix “_2”. For example if the input is myfile.SAP, then the
output will be myfile_2.SAP and will not replace the original input file.
14.3
When Trying To Install The CYCLONE Software, A Popup WDREG Error Occurs Telling
Me That There Are Open Devices Using WinDriver.
Figure 14-1: WDREG Error Message
The error is that the USB Driver (WinDriver) used by PEmicro devices and software is currently in
use and can't be upgraded as such. The simple solution is to shut down any PEmicro software and
also unplug any PEmicro Cyclone, Multilink, and OpenSDA devices. If the error pops back up upon
Retry, or you are remote from the machine itself, go to the Windows Device Manager and right
click on each Multilink, Cyclone, and OpenSDA device and select “Disable”.
Figure 14-2: Disable Interfaces In Windows Device Manager
Upon clicking the Retry button in the installer, the drivers should now install and the devices will be
automatically re-enabled.
