35
Antenna location
ENGLISH
Complete antenna location
When antenna location is complete, click the [Antenna location complete] button.
memo
Important
●
If you move or change the antenna while working in other tabs (such as “Mapping” or “Mic location/analysis”), the
active tab changes to “Antenna location/analysis”. If you move an antenna, change the number of antennas, or
change the settings, click the “Antenna location complete” button to update the changes.
X
If an error occurs with antenna location
If an error occurs with antenna location, the “Reconsider the antenna location” error message appears and the area where
the error occurred is indicated by a red frame as shown in the figure below.
Cause of error
An error occurs because the antenna coverage area does is not large enough to cover the size of the area (room).
For example, if the setting of “[Mic usage side]” (page 20) for an area is [All], an error will occur if the antenna
coverage area does not extend to the four corners of the area (room).
In the case of the figure above, an error occurs because the placed antennas cannot cover to the upper side part of
Area3.
Solution
Add an antenna so that the antenna coverage area is large enough to cover the entire area or revise the [Mic usage
side] setting. Also perform the procedure described in “[Change TX PWR]” (page 33) if necessary.
In the case of the figure above, you need to place four antennas at ceiling height (recommended location) or set [Mic
usage side] to [Lower side].
