•
Auto pan:
Automatically pans between the start position and the end position set in advance
(
Even when the camera is operated for zooming or focusing, the camera continues panning. (However,
panning will stop when the zoom button (x1) is clicked.)
•
Preset sequence:
Automatically moves to the preset positions (
Page 120) orderly (start from the
lowest preset position number).
•
Patrol 1-4:
Performs patrols 1-4 that were set in advance. (
®
Left-click on the control pad or buttons to adjust the horizontal/vertical position of the camera (panning/
tilting). Panning/tilting speed will be faster if a clicked point gets farther from the center point of the control
pad.
It is also possible to pan/tilt the camera by dragging the mouse.
Zoom and focus can be adjusted by right-clicking. When an upper/lower area of the control pad is
right-clicked, the displayed image will be zoomed in/out on. When a left/right area is right-clicked, the focus
will be adjusted to the Near/Far side.
Zoom can also be adjusted using the mouse wheel.
[Brightness] buttons
The brightness is adjustable from 0 to 255. Click the
button to make the image brighter, or click the
button to make the image darker. If you click the [Normal] button, the display will be reset to default.
[Preset]
Select a preset position from the pull-down menu and click the [Go] button. The camera will move to the
selected preset position (
Page 120). “H” next to the preset position number indicates the home position.
When “Home position” is selected, the camera will move to the home position. (
®
When “Preset ID” is registered for a preset position, the registered preset ID will be displayed next to the
preset position number.
Camera title
The camera title entered for “Camera title” on the [Basic] tab will be displayed. (
®
Support button
When this button is clicked, the support site below will be displayed in a newly opened window. This website
contains technical information, FAQ, and other information.
http://security.panasonic.com/support/
Alarm occurrence indication button
When an alarm occurs, the display flashes. When this button is clicked, the output terminal will be reset
and this button will disappear. (
®
Note
•
Since the blinking of the alarm occurrence indication button is not coupled to recording images to
the SD memory card, forwarding E-mails, or other operations, check the settings of each operation
separately.
Full screen button
Images will be displayed on a full screen. If the full screen button is clicked once when the image displayed
in the main area is smaller than the main area, the image is displayed corresponding to its image capture
size. If the full screen button is clicked once when images are displayed corresponding to their image
capture sizes, images are displayed in full screen. To return to the “Live” page when displaying an image
in full screen, press the [Esc] key.
Snap shot button
Click this button to take a picture (a still picture). The picture will be displayed on a newly opened window.
When right-clicking on the displayed image, the pop-up menu will be displayed. It is possible to save the
image on the PC by selecting “Save” from the displayed pop-up menu.
When “Print” is selected, printer output is enabled.
Note
•
The following settings may be required.
Operating Instructions
15
1 Operations