2.3 Use Easy Setup [Easy Setup]
The “Easy Setup” page uses simple operations to set the following:
2.3.1 Configure easy installation
In this section, by setting environment information for installation, suitable zoom rate and focus position can
be automatically adjusted.
[Step 1] Input the installation environment
In this section, configure the environmental information such as the height of the camera installation, distance
from the subject, and oscillation angle.
B
C
D
A
E
Select either meters or feet.
[Height]
: Measure and set the height from the ground until the camera installation position.
Up: Raises the installation position of the camera.
Down: Lowers the installation position of the camera.
[Distance]
: Measure and set the distance until the subject (vehicle).
Up: Increases the distance between the camera and subject (vehicle).
Down: Reduces the distance between the camera and subject (vehicle).
[Deflection Distance]
: Set the oscillation angle from the camera installation position to the center of the
road.
Up: Sets to the left side when facing the subject.
Down: Sets to the right side when facing the subject.
[Next]
: Automatic adjustment of the zoom rate and focus position starts according to the installation
environment of
B
to
D
.
Note
•
The default display for this page will always be meters.
•
If it is set to a feet display, it is converted to meters and set. The value for feet may differ slightly after
setting due to calculation error.
Operating Instructions
23
2 Settings
