•
Default:
100pics
H.264 recording(Alarm)
This setting is only available when “H.264(1)” or “H.264(2)” is selected for “Recording format” of the SD memory
card, and “Alarm input” is selected for “Save trigger”.
[Pre alarm (recording) duration]
Determine whether or not to perform the pre alarm recording. Set the duration to save image data on the SD
memory card.
Off/ 2s/ 3s/ 4s/ 5s/ 10s/ 15s/ 20s/ 25s/ 40s/ 50s/ 60s/ 90s/ 120s
•
Default:
Off
Note
•
The available values change depending on the H.264 bit rate selected for recording. As the selected
bit rate increases, the available maximum value for the pre alarm duration decreases.
[Post alarm (recording) duration]
Set the duration to save image data on the SD memory card after an alarm occurrence.
10s/ 20s/ 30s/ 40s/ 50s/ 60s/ 120s/ 180s/ 240s/ 300s
•
Default:
30s
* The actual recording time may sometimes be longer than the duration selected for this setting.
SD memory card information
[Remaining capacity]
Total capacity and remaining capacity of the SD memory card will be displayed.
Depending on the status of the SD memory card, the size indications will differ as follows.
Indication
Description
--------MB/--------MB
No SD memory card is inserted. Failed to obtain available capacity
due to error, etc.
********MB/********MB
The SD memory card is unformatted, or locked (write-protected).
Note
•
When “Off” is selected for “Overwrite” and the available size of the SD memory card is “0 MB”, images
will not be saved on the SD memory card. When the notification function is on, a notification will be
sent to the registered addresses and destinations of the Panasonic alarm protocol when the SD
memory card becomes full. (
[Remaining capacity]
The total capacity and remaining capacity of the SD memory card will be displayed.
[Format]
To format the SD memory card, click the [Execute] button.
74
Operating Instructions
10 Configure the basic settings of the camera [Basic]
