[FTP server address]
Enter the IP address or the host name of the FTP server.
•
Available number of characters:
1 - 128 characters
•
Available characters:
Alphanumeric characters, the colon (:), the period (.), the underscore (_), and the
hyphen (-).
IMPORTANT
•
When entering the host name for “FTP server address”, it is necessary to configure the DNS settings
on the [Network] tab of the “Network” page. (
[User name]
Enter the user name (login name) to access the FTP server.
•
Available number of characters:
1 - 32 characters
•
Unavailable characters:
" & : ; \
[Password]
Enter the password to access the FTP server.
•
Available number of characters:
0 - 32 characters
•
Unavailable characters:
" &
[Control port]
Enter a control port number to be used for the FTP server.
•
Available port number:
1-65535
•
Default:
21
The following port numbers are unavailable since they are already in use.
20, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 443, 995, 10669, 10670
[FTP mode]
Select “Passive” or “Active” for the FTP mode.
Normally, select “Passive”. When it is impossible to connect after select “Passive”, try to connect after selecting
“Active”.
•
Default:
Passive
16.3 Configure the settings relating to the NTP server
[NTP]
Click the [NTP] tab on the “Server” page. (
The settings relating to the NTP server such as the NTP server address, port number, etc. can be configured
on this page.
Operating Instructions
163
16 Configure the settings of the servers [Server]
