4.
Configure the settings of Camera 2 (IP address: 192.168.0.12), which receives notification commands from
the other cameras.
Display the “Alarm” screen from the “Alarm” page. (
From “Alarm”, set “Command alarm” to “On” and click the “Set” button.
Set the “Command alarm” of “Camera action on alarm” to “Preset per sender”, and click “Preset per
sender >>”.
On the “Preset per sender” page (
page 138), check the “Auto track cooperation” checkbox of
“Sender’s address 1” (any destination address can be used) and enter 192.168.0.11 (Camera 1) for
the sender’s address. Then select the preset position set at step 2, click the “Set” button, and then
close the page.
Click the “Set” button.
5.
Auto track cooperation can be used by starting the auto tracking for Camera 1.
11.6.8 Configure the settings relating to direction (“Direction”
setup menu) (SW396/SC386)
Click the [Setup>>] button of “Direction” on the [Image/Position] tab of the “Image/Audio” page (
Here the information related to the direction setting is set. The pan/tilt position moves to the position set when
displaying this page.
Direction setting
[North point setting]
If “Direction display” is selected for “Camera position display”, one of the eight directions will be indicated
instead of the preset position title when the camera is not at the preset position.
Determine the direction setting by adjusting the displayed panning position to the north (N) indication.
[Zoom] buttons, [Focus] buttons, [Brightness] buttons, Control pad/buttons and [Go] button
Refer to page 12 for descriptions of how to operate these buttons/pad.
126
Operating Instructions
11 Configure the settings relating to images and audio [Image/Audio]
