15
7. Add “SFTP periodic image transmission error” to “Save trigger” of SD
memory card
(Operating Instructions – Configure the basic settings of the camera [Basic] – Configure the
settings relating to the SD memory card [SD memory card])
With the addition of the SFTP function, “SFTP periodic image transmission error” has been added to the
“Save trigger” of the Recording stream.
Recording stream
[Save trigger]
Select a trigger to save images on the SD memory card from the following.
•
SFTP periodic image transmission error:
Saves images when images have failed to transmit to the
SFTP server by the SFTP periodic image transmission function. Available only for the “JPEG (1)” or
“JPEG(2)” images.
•
Alarm input:
Saves images at an alarm occurrence.
•
Manual:
Saves images manually.
•
Schedule:
Saves images in accordance with the settings for “Schedule” (→“Configure the settings
relating to the schedules [Schedule]”). Available only for the “Stream (1)” or “Stream(2)” images.
•
Default:
Manual
If you have selected “Alarm input” in the [Save trigger], you can select the alarm type from the following:
•
Terminal 1:
Save the image when an alarm occurs in Terminal 1.
•
Terminal 2:
Save the image when an alarm occurs in Terminal 2.
•
Terminal 3:
Save the image when an alarm occurs in Terminal 3.
•
VMD:
Save the image when motion detection occurs.
•
Command alarm:
Save the image when a command alarm is entered.
Note
• When “Stream (1)” or “Stream(2)” is selected for “Recording format”, “SFTP periodic image
transmission error” is unavailable.
• To enable alarms to occur, alarm settings must be configured in advance on the [Alarm] tab.
• When “JPEG (1)” or “JPEG(2)” is selected for “Recording format”, “Schedule” is unavailable.
• When connected with our network disk recorder, “Save trigger” may be displayed in a gray-out state
as “Network failure”. To change the setting of “Save trigger” after disconnecting the recorder, set “Not
use” for “SD memory card” once and then set “Use” again.
