When using the IR LED to view images in a dark environment, reflections from the wall may cause all or a part of the image to
appear washed out. Refer to our website (https://security.panasonic.com/support/info/) for further information about detailed
example. (WV-S2531LTN･WV-S2531LN･WV-S2511LN･WV-S2231L･WV-S2211L･WV-S2131L･WV-S2111L)
1. Take care of the following points when mounting the enclosure after adjusting the viewing angle.
①
Mount the enclosure after confirming that the Sealing
rubber ring attached to the groove has not come away
from the groove. (WV-S2531LTN･WV-S2531LN･WV-S2511LN)
②
Align the
▽
mark on the camera body with the LOCK line
on the enclosure and then mount the enclosure to the camera
body at a straight angle. (WV-S2531LTN･WV-S2531LN･WV-S2511LN)
Mount the enclosure to the camera body at a straight angle.
(WV-S2231L･WV-S2211L･WV-S2131L･WV-S2111L)
If the enclosure is not mounted to the camera body at
a straight angle, the inside of the dome cover may make
contact with the camera portion, which may result in the
configured viewing angle moving out of alignment.
The light-blocking rubber ring may be stretched depending
on the tilt angle. This will not damage the light-blocking rubber ring.
③
Push the wires from the camera portion into the camera body so that
they do not come out from the internal wall of the camera body.
2
. Take care of the following points when adjusting the angle of view.
When using the camera at a vertical position angle of 75°or more (position where the camera
lens is nearly horizontal), part of image may appear to be overlapped.
To prevent overlapping, decrease the vertical position angle or adjust the zoom ratio.
Cautions for using the IR LED
Cautions for mounting the enclosure
Camera portion
Enclosure
Camera body
Light-blocking
rubber ring
Internal wall
Dome cover
Sealing rubber ring
(gray area)
