51
Setting the FTP server [FTP]
Click the [FTP] tab on the "Server setup" page.
On this page, the settings for the FTP server that sends alarm images can be configured.
No.
Item
Description
(1)
[FTP server address]
Enter the IP address or host name of the FTP server used to send
images. To enter the host name for "FTP server address", it is necessary
to configure the DNS settings on the [Network] tab of the "Network setup"
page. (
Number of characters for the FTP server address: 1 to 128
(2)
[User name]
Enter the user name to access the server.
Number of characters for the user name: 1 to 32
(3)
[Password]
Enter the password to access the server.
Number of characters for the password: 0 to 32
(4)
[Control port]
Default: 21
Enter a control port number to be used for the FTP server.
Available port number: 1 to 65535
(5)
[FTP mode]
Default: Passive
Select the FTP communication mode for when images are sent.
................................................................................................................
Note
• Normally, select "Passive". When a connection cannot be established
in the "Passive" mode, select "Active".
.....................................................................................................................
Passive
Sets the FTP communication mode to "Passive".
Active
Sets the FTP communication mode to "Active".
(1)
(2)
(3)
(4)
(5)
