Panasonic Workio DP-C405, Service Handbook

Page: 435 / 808

435
DP-C405/C305/C265
FEB 2008 Ver. 1.1
4.2. Service Modes (For Facsimile)
Caution:
The factory default parameters are preset (destination dependent) for optimum performance, and in
compliance with the local telecommunication regulations/standards, and do not need to be changed.
Changing some of these parameters may cause the unit to be no longer compliant, or become
inoperable.
4.2.1. Fax Service Mode Procedure
To enter the Fax Service Mode
The service mode is selected when the “Function” , “Copy” , and “3” keys are simultaneously
pressed, “Input the password” to enter the Service Mode (default password is 00000000 ), then F1
will appear in the display.
Set the machine to Service Mode, and press the “9” key on the Control Panel.
↓
Press the “Start” key to enter the F9 Service Mode on the Control Panel.
↓
Select “00 Fax Service Mode” on the Touch Panel display.
↓
Select the desired function, or code number on the Touch Panel display, and then select the “OK”
button.
When the
“Cancel” button is selected, the selected code input will not be accepted.
↓
Select the “Close” button three time on the Touch Panel display.
↓
Press the “Function” , and the “C (Clear)” keys simultaneously on the Control Panel to exit the
Service Mode.
↓
Reboot the machine after setting the parameter(s) to activate the setting(s). (Turn the Power Switch
on the Left Side of the machine to the
OFF then back to the ON position.)
Note:
The following buttons provide these functions in the Service Mode:
“Start” : The new setting value is stored in the machine.
“ ”
: Scroll the function parameter number down.
“ ”
: Scroll the function parameter number up.