Panasonic WORKIO DP-C323, Operating Instructions Manual

Page: 34 / 220

34
Chapter 2 Basic Fax Transmission
Verification Stamp
This function confirms successful transmission, or storage
into the memory by stamping at the bottom of each
successfully transmitted original(s) with a small “x” mark.
z The standard setting of the verification is “ Off ”. The stamp setting can be changed with “ 04 Stamp (HOME) ” in
Function Parameters (Fax/Email Settings> Fax Parameters). For instructions on how to change the standard setting,
refer to Fax/Email Settings in the Operating Instructions (For Function Parameters) on the provided CD-ROM.
z The machine can be configured not to stamp the documents stored in the memory by changing the setting
“ 28 Stamp at Memory XMT ” in Function Parameters (Fax/Email Settings> Fax Parameters). For instructions
on how to configure the verification stamp, refer to Fax/Email Settings in the Operating Instructions (For
Function Parameters) on the provided CD-ROM.
z Verification Stamp function is only available when scanning documents with the ADF.
z Because the verification stamp cannot be deleted, be careful not to use the verification stamp when
transmitting important document(s).
1
Place Original(s).
z Refer to Placing Originals (Facsimile/Internet
Fax) in the Operating Instructions (For Basic
Operations) of provided booklet.
2
Press the Fax key.
3
Select “ Basic Menu ”.
4
Select “ Verification Stamp ”.
5
Set “ Quality Adj. ” as required.
z Refer to Setting Original Quality (see page
26).
6
Select “ Address Book ”, and then
select a destination.
z Refer to Entering a Destination (see page
16).
7
Press the Start key.
The original(s) are stored into memory with a
file number. Then starts dialing the telephone
number.
z The setting of the “ Verification Stamp ” is
returned to the “ Off ” position after the
transmission is completed.
Verification Stamp
Ex : Scanning
Direction
画像ファイル名、
image̲026̲2.tifに変更してリンクしていま
す。