Panasonic Workio DP-C305, Service Manual

Page: 192 / 920

192
FEB 2008 Ver. 1.1
DP-C405/C305/C265
3.6. Lubrication Point
Please refer to the Preventive Maintenance (PM) list to ensure the highest degree of reliability. The
inspection interval is usually 120K copies or more, however this interval may be reduced due to
environmental conditions.
3.7. Easy Maintenance (DP-C405 Series)
3.7.1. Outline
This is a new function that stores machine maintenance and machine status history which can be helpful to
Service Technicians when performing service maintenance and/or repairs.
Use this feature to record and print machine maintenance information, such as, the Service Visit Dates and
Service Details.
Machine counter information is collected and can be printed with machine illustrations and graphs, which
helps to keep the machine in good working condition, and enables to easily estimate when parts/supplies
should be changed.
With the Fax Service Mode 8 (Check & Call) also enabled, your will be alerted of machine problems,
maintenance alerts, and when supplies are needed automatically.
To enable this function, the following data input is necessary.
First register the customer's information when the machine is installed.
Then at each service visit, register what Service Action was performed. Refer to the Steps below.
3.7.2. How to Input the Service Information/History, and How to Out put the List
Step 1. Only when installing the new machine
Input the Customer’s Information (Refer to 3.7.3. Procedure 1.)
Step 2. When servicing this unit the 1st time of the day
Input the Service History (Refer to 3.7.3. Procedure 2.1.)
Step 3. When re-visiting the customer the 2nd time on the same day
Input the Service History (Refer to 3.7.3. Procedure 2.2.)
Step 4. Printing the Service Information List
Print the Service Information List (Max. 200) (Refer to 3.7.3. Procedure 3.)
Note:
This Function will start working the day after the customer's information has been registered.
(This prevents the Register Service Action screen from appearing each time when exiting the Service
Mode while the machine is being configured during the installation.)