80
Problem Solving
Battery Holder
Remove 1 Screw.
Remove the Battery Holder.
Replacing the Battery/Set the Date and Time
The machine has an internal battery
(Product No.:
CR2032
) which maintains
the date and time.
In the event the battery requires
replacement, the following message will
be displayed.
Turn the Power Switch on
the Right Side of the
machine to the OFF
position.
If the Hard Disk Drive Unit
(DA-HD18)
is installed, see
1
2
6
REPLACE BATTERY
U90
10
09 KEY OPERATOR MODE
ENTER PASSWORD=
11
KEY OPR.MODE (00-34)
ENTER NO. OR
∨
^
or
17 (DATE & TIME)
NOTE
●
The service life of the battery is approximately 1 year under normal use.
3-digit
(See page 13)
When setting the Date and Time, start
from step 6.
Set the Date and Time continues steps 6 to 13.
■
Notice: California only:
This product contains a CR Coin Cell Lithium Battery which contains
Perchlorate Material - special handling may apply.
See
Summary of Contents for Workio DP-8016P
Page 85: ...memo...
