Panasonic Workio DP-8016P, Operating Instructions Manual

Page: 14 / 88

14
Getting To Know Your Machine
INV
INV LTR LGL LDR
LTR
LDR
INV
LTR
LGL
INV
LTR
INV
INV-R
LTR-R
LGL
LDR
Width Guides
Face Down
Until it stops
Upper Limit Guides
Until it stops
Sheet Bypass
PUSH
Paper Tray
Max Level
Indicator
Paper Tray
∗ ∗∗ ∗∗
Hold the guides by the center when
adjusting the width
Operation Chart
If set to other
function mode
(DP-8020E/8020P
only)
Face Up
A B C
From
ADF/i-ADF
(Option)
From
Platen
Face Down
●
If the original is not positioned
properly, a portion of the original
may not be copied.
●
For originals smaller than Invoice
size, position the original within
the Invoice area and select
Invoice.
or
●
Adding Paper (Paper Tray)
The following steps are for Paper Tray-1, use the same procedures for other optional Paper Trays.
●
Adding Paper (Sheet Bypass)
Copying on Special Paper, etc.
Load Paper: Face Up
Paper Weight: 16 - 24 lb (60 - 90
g /m
2
)
Paper Capacity: 550 Sheets (20 lb (80 g /m 2 ))
Adjust the width guides.
Incorrect adjustment may cause the
paper to wrinkle, misfed, or skew.
Original Guides
■
Quick Operation Chart
NOTE:
To change the paper size, refer to
page 62.
1
1 2 3
Adding Paper
Turn the Power
Switch to the
ON position
Original Guides
∗ ∗∗
∗∗
Adjust to the
original's width
Tray
(Max. 50 Letter
size originals)
INV: Invoice, LTR: Letter
LGL: Legal, LDR: Ledger
4
4
Load Paper
(Do not exceed limit guides)
Paper Weight: 15-34 lb (55 - 133
g
/m 2 )
Paper Capacity: 50 sheets/20 lb (80 g /m
2
)
To add paper to the Sheet Bypass,
remove the leftover paper from the
tray, and align it with the additional
paper, then load them together onto
the tray.
NOTE:
Load the paper properly, and ensure
that it does not exceed the Max. Level
indicator.
2
1 2 3
(ON)
(OFF)