14
Major operating controls and their functions
(continued)
Rear view
①
④
⑥
⑧
⑨
⑩
⑪
②
③
⑤
⑦
①
Clamp mount (To prevent power cord disconnection)
②
Alarm/Control terminal [ALARM/CONTROL]
It is used when connecting with an external device such
as a sensor or anti-theft door switch that output alarm
signals, or when connecting with an external alarm
equipment such as a buzzer or a lamp.
③
DC jack [DC IN]
Connect the DC plug of the included AC power adapter.
Make sure that you insert the DC plug all the way to
provent from loosening or coming off.
Secure the DC cable with a cable clamp so that the DC
plug will not come off.
(Refer to "How to prevent DC plug disconnection" on
page 15)
DC jack
DC plug
DC cable
AC power adapter
(included)
Power cord (included)
Power plug
④
Network port (Camera port) [CAMERA]
Connect the recorder with a PC and cameras via a
network compatible with 10BASE-T or 100BASE-TX.
When the port is being accessed, the access indicator
(green) lights. When the port is supplying power, the PoE
indicator (orange) lights.
Access indicator
PoE indicator
PoE indicator
Access indicator
Note:
• The camera port comes with the PoE power supply
function that complies with IEEE802.3af.
• The camera number detected at Easy Start does not
match the camera port number (P1 - P4) on the rear
panel of the recorder.
⑤
Network port (PC port) [PC]
Connect the recorder with a PC via a network
compatible with 10BASE-T, 100BASE-TX or
1000BASE-T. The right lamp (yellow) only lights up at
1000M connection. The left lamp (green) only lights up at
100M connection. Both lamps light up at 10M
connection. The lamp blinks when sending or receiving
data.
⑥
SIGNAL GND terminal [SIGNAL GND]
Connect this terminal with the SIGNAL GND terminals of
the devices in the system for signal ground. When
operating the recorder and the devices in the system
without signal ground, noise may be produced.
