Panasonic VL-W1-N Series, Setup And Maintenance Manual

Page: 81 / 176

81
3-5-3 Remote mode settings
To control the laser welding machine externally using I/O or serial communication commands, set the operation mode to
the remote mode with one of the following methods.
Select the method to switch to the remote mode by setting the DIP switch on the rear side of the controller.
Use the remote switch on the front of the controller.
Turn ON the remote mode switch on the front of the controller.
Turn OFF the DIP switch No. 5.
Refer to “1-6-3 DIP switch” (P.38).
Use input signal of X5 “REMOTE IN” on I/O terminal.
Turn ON REMOTE IN (X5) of the I/O terminal on the rear of the controller.
X5: REMOTE IN
Turn ON the DIP switch No. 5.
Refer to “1-6-3 DIP switch” (P.38).
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• When DIP switch No. 5 is ON, the remote switch on the controller is not available.
Start the laser welding machine in the remote mode
The laser welding machine starts up always in the remote mode state. Use the remote mode switch button of the controller
for releasing and resetting the remote mode.
ヱヰヸユ
ン
OFF
ON
Turn OFF the DIP switch No. 5 and turn ON the DIP
switch No. 6.
Refer to “1-6-3 DIP switch” (P.38).
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• When DIP switch No. 6 is ON, “X5: REMOTE IN” signal on I/O terminal is not available.
• The remote switch on the controller is available when DIP switch No. 6 is ON.
ME-VLW1N-SM-1