Panasonic VL-MWD272, Operating Instructions Manual

Page: 26 / 40

9.1 Registering sub monitors and
extension monitors
Extension monitors and additional sub monitors can be
registered to the main monitor.
9.1.1 Registering sub monitors (main
monitor and sub monitors only)
1
Main monitor:
Press M N
®
select “
Register/Cancel
”
®
.
2
Select “
Register
”
®
.
R When you are prompted to register your main
monitor, select
“
Main monitor
”
®
.
3
Select “
Sub monitor
”
®
.
4
Select the registration number of the sub monitor to
be registered
®
.
R Complete the following operations within about 2
minutes.
5
Sub monitor:
R To register a sub monitor for the first time:
When
“
Please register the device.
” is
displayed on the screen, select
®
.
– “
Registering completed
” is displayed.
R To re-register a sub monitor:
Press
M N
®
select “
Register
”
®
®
.
– “
Registering completed
” is displayed.
6
Main monitor:
Press M N .
9.1.2 Registering extension monitors
1
Main monitor:
Press M N
®
select “
Register/Cancel
”
®
.
2
Select “
Register
”
®
.
R When you are prompted to register your main
monitor, select
“
Main monitor
”
®
.
3
Select “
Extension monitor
”
®
.
4
Select the registration number of the extension
monitor to be registered
®
.
5
Extension monitor:
Press M N
®
select “
Register/Cancel
”
®
.
6
Select “
Register
”
®
.
R When you are prompted to register your
extension monitor, select
“
Extension
monitor
”
® ®
.
7
Select the registration number of the extension
monitor to be registered
®
.
R Make sure to select the same registration number
that was selected on the main monitor.
R Registration is complete when the extension
monitor restarts.
8
Main monitor:
Press M N .
9.2 Using repeaters
If the sub monitor is used away from the main monitor,
or if there are obstructions (page 8) between the sub
monitor and the main monitor, the following problems
may occur. In these cases, using a repeater (additional
accessory; page 4) may improve transmissions between
the devices.
– calls with the sub monitor cut out and images are
distorted
– when is displayed in the sub monitor and the main
monitor cannot connect to the sub monitor
Note:
R A maximum of 2 repeaters can be used. A single
repeater can be used to send signals to multiple sub
monitors.
R Signal range differs depending on factors such as the
structure of rooms or the types of walls used. After
registering devices to the main monitor (page 27),
see the repeater's Getting Started for information
about appropriate installation locations.
Signal range and repeater installation example
Using each repeater connected separately
(“
Connect separately
” setting page 24)
This extends signals away from the main monitor. This
is useful when you want to extend the range around the
main monitor and connect to sub monitors over shorter
distances.
When repeaters are not used:
26
9. . Expanding the system
9. Expanding the system