View Tag
Product Family
User Information Guide
2.2.2021
Document:
SPC-ENG-0000004-03
page
15
of
19
Regulatory Certifications
This product meets the requirements mandated by the following regulations and standards. Note that no claim is made that our
products conform to regulations and standards of countries and regions not mentioned in this section. When exporting product by
itself or integrated into a machine or device, confirm the regulations and standards of the exporting country or region.
VIEW 3
VIEW 4
VIEW 7
Model Number
VT03-G3
VT03-G3C
VT04-G3
VT04-G3C
VT07-G3
EN Standard*
EN 300 220-2 V3.2.1
ETSI EN 301 489-1
ETSI EN 301 489-3
EN 55032:2015/AC:2016
EN 55024:2010
EN 61000-4-2:2009
EN 61000-4-3:2006: +A1:2008 + A2:2010
FCC
FCC Part 15 subpart C
FCC Part 15.231
FCC Part 15 subpart B
IC
RSS-210
ICES-003
Safety
IEC/EN 62368-1
*
Contact for CE: Panasonic Marketing Europe GmbH, Panasonic Testing Center, Winsbergring 15, 22525 Hamburg, Germany
FCC Interface Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
•
Consult the dealer or an experienced radio/TV technician for help
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
FCC Caution
: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate this equipment.
Industry Canada Statement
This device complies with Industry Canada
license- exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this
device may not cause interference, and (2) this
device must accept any interference, including
interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes: (1)
l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre
le fonctionnement.
