FAQs | On-screen messages
104
Problem
Causes / Actions
Other
The TV does not switch on
●
Press and hold the Standby On / Off switch on the remote control for about
1 second if Power LED is red.
●
Check the mains lead is plugged into the TV and the socket outlet.
●
The fuse in the mains plug may have blown. Replace it with one of an identical
rating.
(p. 4)
The TV goes into Standby
mode
●
Auto power standby function is activated.
(p. 12)
●
The TV enters Standby mode about 30 minutes after analogue broadcasting
ends.
The remote control does
not work or is intermittent
●
Are the batteries installed correctly?
(p. 8)
●
Has the TV been switched on?
●
The batteries may be running low. Replace them.
●
Point the remote control directly at the TV’s remote control signal receiver
(within about 7 m and a 30 degree angle of the signal receiver).
●
Situate the TV away from sunshine or other sources of bright light not to shine
on the TV’s remote control signal receiver.
Parts of the TV become
hot
●
Even when the temperature of parts of the front, top and rear panels has risen,
these temperature rises do not cause any problems in terms of performance or
quality.
Permanently lit spots on
screen
●
Due to production process involved in this technology this may result in some
pixels which are permanently lit or unlit. This is not a malfunction.
Overcurrent error
message appears
●
The connected USB device might cause this error. Remove the device and turn
the TV off with Mains power On / Off switch, then turn it on again.
●
Check foreign objects are not inside the USB port.
An error message appears
●
Follow the message’s instructions.
●
If the problem persists, contact your local Panasonic dealer or the authorised
service centre.
On-screen messages
Message
Meaning / Action
All tuning data will be erased
●
[Shipping Condition] will erase all tuning data.
(p. 57)
Are you sure ?
●
Confirm correct operation.
Are you sure you want to
delete this timer ?
Press OK to delete timer.
Press RETURN to return.
●
Confirm correct operation.
Bad signal
●
The signal is weak. Check the aerial is plugged in properly. It may be
necessary to have an aerial installer check the signal and aerial alignment.
●
Reset channels.
(p. 50)
Child Lock is active!
Press OK to enter PIN.
●
The selected channel is locked in Child Lock (p. 56). You must enter the PIN
number before the channel will be displayed.
External Recording Due to
Start
●
This message will appear 2 minutes before timer programming event for
external recording due to start.
Feature not available.
●
It is not possible to record from AV2 (COMPONENT) or HDMI. Connect the
recorder to the TV using a fully wired SCART cable for recording from the TV
tuner.
●
Confirm Q-Link or VIERA Link settings.
(p. 84 - 87)
Feature not available.
Press OK to view how it works.
●
The selected feature on VIERA TOOLS is not available. Press the OK button to
view the demonstration to explain how to use it.
Found new software version
∗∗∗
.
Press OK to start update (may
take over 40 mins) or press
EXIT to ignore and you can
update when TV is in standby
●
There is a new software available.
Invalid operation - Please
check settings and
connections.
●
Check the Q-Link or VIERA Link connection and setting.
(p. 84 - 87)
