FAQs, etc.
45
Problem
Actions
Chaotic image, noisy
•
Set "P-NR" in the Picture menu (to remove noise). (p. 21)
•
Check nearby electrical products
(car, motorcycle,
fl
uorescent lamp).
No image can be
displayed
•
Is "Colour" or "Contrast" in the Picture menu set to the
minimum? (p. 21)
Blurry or distorted image
(no sound or low volume)
•
Reset channels. (p. 28 and p. 30)
•
Frequently Asked
Questions
Screen
HDMI
Sound
DVB
No sound is produced
•
Is "Sound Mute" active? (p. 7)
•
Is the volume set to the minimum?
Sound is unusual
•
Set the sound setting of the connected equipment to
"2ch L.PCM".
•
Check the "HDMI1 input" setting in the Sound menu. (p. 21)
•
If digital sound connection has a problem, select
analogue sound connection. (p. 21)
Sound level is low
or sound is distorted
•
Sound signal reception may be deteriorated.
•
Set "NICAM" (p. 20) in the Sound menu to "Off".
(Analogue only)
TV unit goes into
"Standby mode"
•
The sleep function is activated.
•
The TV unit enters "Standby mode" about 30 min.
after broadcasting ends.
The remote control
does not work
•
Are the batteries installed correctly? (p. 6)
•
Has the TV unit been switched On?
Pictures from external
equipment are unusual
when the equipment is
connected via HDMI
•
Is the HDMI cable connected properly? (p. 40)
•
Turn Off the TV unit and equipment, then turn them On
again.
•
Check an input signal from the equipment. (p. 43)
•
Use an equipment compliant with EIA/CEA-861/861B.
Interference or
frozen / disappearing
image in DVB
•
Check "Signal Condition". (p. 28)
If "Signal Quality" or "Signal Strength" are displayed in
red, check aerial.
If problem persists, consult your local Panasonic dealer.
•
Use the remote control to turn Off the TV unit, then turn
it On again.
•
Due to the digital reception technologies involved, quality of the DTV signals may be relatively low in
some cases, despite good reception of analogue programmes.
Other
"Control with HDMI"
function does not work
•
Switch the TV unit on again with the equipment on.
•
Set "Control with HDMI" to "Off", then set to "On"
again. (p. 38)
Ofrecido por www.electromanuales.com