MODEL: Miniature Camera
PCF1, PCV1
PRODUCT INSTRUCTIONS
STANDARD INSTALLATION PROCEDURE
INCLUDES MODELS: PCF1, PCV1
CONTENTS INCLUDE:
(1) Housing
(1) Weather hood
(1) Cover plate
(1) Cover plate gasket
(1) Allen wrench security head tool
(2) Stainless steel 6-32x1/2" captive Security head screws
(1) Camera mount bracket
(1) Camera bracket arm
(1) Bottom mount bracket with PC Board
(1) Top mount bracket with camera and lens
(2) 4-40 x 1/4" screws
(2) Star washers
(4) 2-56 x 3/16" screws
1.
Remove the cover plate by loosening the 2 security head
screws with the security tool.
2.
If mounting the unit to a wall:
A. Remove the 2 Phillips head screws that secure the
bottom mount bracket and PC Board to the housing,
then remove the bracket. Repeat for the top mount
bracket and camera.
B. Place the housing face down on a flat surface and use
a hammer to remove the knockout located at the
center of the back of the housing.
C. Use the 2 mounting holes and the appropriate
hardware (not included)to secure the housing to the
wall.
3.
If mounting the unit on a pedestal:
NOTE:
3/4" conduit with a threaded end is required for this
method of installation.
A. Install the conduit in the desired location; run the
wiring through the conduit.
B. Place the PFC1/PCV1 housing onto the conduit, feed
the wires through the bottom hole and thread the
housing onto the conduit until tight.
N
NOTE:
Apply silicone sealant to the conduit threads and
the hole plug to ensure a water tight seal.
4.
Make the necessary connections to the PC Board and
reattach the bottom bracket to the housing.
Top mount bracket and camera
Bottom mount bracket and PC Board
USE CLASS 2 POWER ONLY
!
5.
Hand place the top bracket and camera into the unit.
Check the angle of the camera, remove the bracket/
camera and make any necessary adjustments. Once
you have achieved the desired camera angle, reattach
the top bracket and camera to the housing.
6.
Fine focusing (see diagram below):
Fixed Lens: Manually rotate the lens until a clear picture is
achieved.
Vari-Focal Lens: First, adjust the Magnification Lock Screw
to the desired magnification (telephoto
to wide angle). Tighten the Lock Screw.
Next, adjust the Focus Lock Screw until a
clear picture is achieved. Tighten the
Lock Screw.
Fixed Lens Camera
(PCF1)
Vari-focal Lens Camera
(PCV1)
Manual focus
Focus Lock Screw
Magnification
Lock Screw
Camera Fine Focus
Manufactured by:
for
Before attempting to connect or operate this product, please read these instructions completely.
81-IN3046-9922
DESCRIPTION
: Outdoor Pedestal Mount Housing,
Color Camera
