Panasonic Vericam 35, Operating Manual

Page: 57 / 119

– 57 –
Chapter 6 Audio recording — Selecting audio input and adjusting recording levels
2
From [SYSTEM] → [AUDIO] → [VR/IN/OUT], set [IN].
For [CH3/4], switch to [CH1/2] in [to CH1/2].
3
Select [MANUAL] in [FRONT1 LEVEL] or [FRONT2 LEVEL].
If [AUTO] is selected, [A] is displayed on the [VR] screen and manual adjustment is not possible.
4
From [SYSTEM] → [AUDIO] → [VR/IN/OUT], select [VR].
5
Make adjustments using [FRONT1 + ]/[FRONT1 − ] or [FRONT2 + ]/[FRONT2 − ] while viewing the audio channel level meter display.
When the topmost bar (0 dB) is exceeded, the red bar display lights up to indicate that input volume is excessive. Adjust the maximum level so that
the display does not reach 0 dB.
r
Recording standard level
In [MENU] → [SYSTEM SETTINGS] → [AUDIO LEVEL] → [HEADROOM], [18dB] or [20dB] can be selected.
Common settings for channels 1 through 4.
@ @ NOTE
t
When the level adjustment is set to [MANUAL], set whether to enable [FRONT1 LIMITER]/[FRONT2 LIMITER]/[REAR1 LIMITER]/[REAR2 LIMITER]
in [MENU]
→ [SYSTEM SETTING] → [SYSTEM MODE] → [AUDIO LEVEL]. This is set to [OFF] in the factory settings.
Audio monitor (headphones)
You can listen to the camera’s audio using headphones.
1
Press the <HOME> button to display the HOME screen.
2
From [SYSTEM] → [AUDIO] → [VR/IN/OUT], select [OUT].
r
Setting the headphones output audio
1
Select the output signal (mono, stereo, mix) in [MONITOR].
r
Adjusting the headphones output audio level
1
Adjust with the [MON + ]/[MON − ] dial.