Panasonic VDR-M50GC, Instruction Manual

Page: 69 / 171

English
VQT0K98
70
12
Removing and Replacing from/in Round DVD Holder
How to Remove Disc
1
Hold the Round DVD
Holder with SIDE A facing
up. While pushing the two
release levers in the
direction of arrows (1)
marked on holder, slowly
open SIDE A of the holder
in the direction of arrows
(2), taking care not to drop
the disc.
2
Without touching the
recording/playback
surface, hold the disc edge
and centre hole to remove it.
Replacing Disc in Round DVD Holder
1
Open SIDE A of the Round DVD Holder, and
replace the disc in the holder with the SIDE A
mark or label surface facing up, taking care not
to touch the disc surface.
2
Close SIDE A of the Round DVD Holder, and
push it to lock the release levers at positions (3).
When the Hinge of Round DVD Holder
Comes off
1
Push the hinged portion of the holder piece
marked SIDE A with thumb and middle finger,
and warp it in the direction of arrows (4).
2
Fit the hinged portion of the other holder piece
into the warped hinge portion.
Note
:
•
Handle the disc carefully so that no scratch, dirt,
fingerprint or dust adheres to the recording/playback
surface.
•
When not using the Round DVD Holder, store it in case:
Do not leave a bare holder as is.
•
Be careful of drop or impact: If you drop the Round DVD
Holder, the disc may pop out.
•
Do not subject the Round DVD Holder to force.
Disc Cleaning
Use a soft, dry cloth to lightly wipe off any dust, dirt,
etc. adhering to disc, as shown in the figure. Never
use solvent. Do not use thinner, water, anti-static
spray, etc. to clean disc.
1
1
2
2
SIDE A mark
Release
levers
Do not open
more than 90°.
90°
3
3
SIDE A
mark
OPEN marks
SIDE A mark side
or label surface
4
SIDE A mark side Hinged portions
Approx. 90°
Use soft cloth to clean
from inner to outer
circumference in axial
direction.
238
ENG.book Page 70 Tuesday, March 23, 2004 8:12 PM