Panasonic Varicam 35, Operating Manual

Page: 94 / 174

– 94 –
Chapter 9 Other Useful Functions — Handling setting data
-
MMC (Multi Media Card) cannot be used. (Bear in mind that taking pictures may no longer be possible if you use them.)
-
When using miniSD/microSD cards with the camera, always install the adaptor specially designed for miniSD/microSD cards. (The camera will not
work properly if only the miniSD/microSD adaptor is installed. Make sure that the card has been inserted into the adaptor before use.)
-
Use of Panasonic SD memory cards and miniSD/microSD cards is recommended. Be sure to format cards on the camera before use.
-
Refer to our support desk at the following website for the latest information not included in this document.
http://pro-av.panasonic.net/
-
SDHC memory cards are a standard that was established in 2006 by the SD Association for large-capacity memory cards that exceed 2 GB.
-
SDXC memory cards are a standard that was established in 2009 by the SD Association for large-capacity memory cards that exceed 32 GB.
Removing SD memory cards
After opening the slot cover and making sure that the busy lamp is not illuminated, push the SD memory card further into the camera and then release.
This releases the SD memory card from the card slot. Remove the SD memory card and close the slot cover.
Note the following points when using or storing memory cards.
f
Avoid high temperature and humidity.
f
Avoid water droplets.
f
Avoid charging with electricity.
Store the SD memory card with the card still inserted into the camera and with the slot cover closed.
Performing operations on SD memory cards
If the SD memory card that was formatted in a standard other than the SD/SDHC/SDXC standards on a device other than the camera is inserted,
[LOAD] or [SAVE] operation of the file cannot be performed. Format the SD memory card again.
Formatting SD memory cards
1
From [MENU]
→
[SYSTEM SETTINGS]
→
[CARDS/MEDIA]
→
[FORMAT CARD], select [SD CARD], and press the jog dial button.
The confirmation screen is displayed.
2
Select [YES] on the confirmation screen, and press the jog dial button.
When not formatting, select [NO], and press the jog dial button.
3
When the completion message is displayed, select [OK], and press the jog dial button.
For details on error messages, refer to “During thumbnail and menu operation” (page 164).
@ @
NOTE
t
Data deleted as a result of formatting cannot be restored. Always check the data before formatting.