FA
Qs | On scr
een messages
102
Problem
Actions
O
ther
The remote control
does not work or is
intermittent
•
Are the batteries installed correctly?
(p. 7)
•
Has the TV been switched On?
•
The batteries may be running low. Replace them.
•
Point the remote control directly at the front of the TV (within about 7 m and a 30
degree angle of the front of the TV).
•
Situate the TV so that sunshine or other sources of bright light do not shine on the TV’s
remote control signal receiver.
Parts of the TV become
hot
•
Temperature rises of parts of the front, top and rear panels will not pose any problems in
terms of performance or quality of the TV.
The LCD panel moves
slightly when it is
pushed with a finger
Clattered sound might
be heard
•
There is some flexibility around the panel to prevent damage to the panel.
•
The panel might move slightly when it is pushed with a finger, and clattered sound
might be heard. This is not a malfunction.
Overcurrent error
message appears
•
The connected USB device might cause this error. Remove the device and turn the TV
Off with Mains power On / Off switch, then turn it On again.
•
Check if foreign objects are inside the USB port.
An error message
appears
•
Follow the message’s instructions.
•
If the problem persists, contact your local Panasonic dealer or the authorized Service Centre.
On screen messages
Message
Meaning / Action
All contents will be lost.
Are you sure to delete this device?
•
Once you format the USB HDD, all the recorded programme will be erased.
All tuning data will be erased
•
[Shipping Condition] will erase all tuning data
(p. 49)
Are you sure ?
•
Confirm correct operation.
Are you sure you want to delete
this timer ?
Press OK to delete timer.
Press RETURN to return.
•
Confirm correct operation.
Bad signal
•
The signal is weak. Check the aerial is plugged in properly. It may be necessary to
have an aerial installer check the signal and aerial alignment.
•
Reset channels.
(p. 40)
Child Lock is active!
Press OK to enter PIN.
•
The selected channel is locked in Child Lock (p. 47). You must enter the PIN number
before the channel will be displayed.
External (USB-HDD) Recording
Due to Start
•
This message will appear 2 minutes before timer programming event for external
(USB HDD) recording due to start.
Feature not available.
•
It is not possible to record from COMPONENT or HDMI. Connect the recorder to the
TV using a fully wired SCART cable for recording from the TV tuner.
•
Confirm Q-Link or VIERA Link settings
(p. 81 - 84)
Feature not available.
Press OK to view how it works.
•
The selected feature on VIERA TOOLS is not available. Press the OK button to view
the demonstration to explain how to use it.
Found new software version
∗∗∗
.
Press OK to start update (may
take over 40 mins) or press EXIT
to ignore and you can update
when TV is in standby
•
There is a new software available.
Invalid operation - Please check
settings and connections.
•
Check the Q-Link or VIERA Link connection and setting
(p. 81 - 84)
Invalid system time. Please exit !
•
Cannot get the time information and cannot edit Timer Programming screen.
Check the connection of the RF cable.
Invalid system time, Timer
Programming will not work.
Please press TV button on
remote control and check time
display on Banner
•
Cannot get the time information. If there is no time displayed on the Information
banner, check the connection of the RF cable.
Max. number of timers already
set !
•
The maximum number of timer programming events is 15.
