Timer Programming
This function allows you to select programmes that you want to record to the
USB HDD.
1. Display
TV Guide
with
GUIDE
.
2. Select the forthcoming programme and press
OK
to access.
●
You can also set a timer event pressing
.
●
To check / change / cancel a timer event
Recording > Timer Programming > Editing Timer Programming
●
LED turns to orange in Standby mode when
Timer Programming
is set.
●
To return to
TV Guide
BACK/RETURN
●
If you select the current programme, a confirmation screen asking
whether you want to watch or record the programme appears. Select
Timer Programming
and press
OK
to set
USB HDD Rec.
to record from
the time you finish the timer event setting.
●
is displayed on the TV Guide screen if
Timer Programming
is set
from
TV Guide
.
●
Depending on the country you select, you can set
Signal Supported
Recording
(see below).
= Note =
●
Not valid in Analogue
●
Timer Programming
only works reliably if correct time information is
received via the signal from the broadcaster or service provider.
●
When recording programmes to the USB HDD, be sure to format the USB
HDD and enable it to record in
USB Device Setup
.
●
To set timer programming events of this TV on the network equipment
(smartphone, etc.) from outside the home network
Recording > Timer Programming > Remote recording
- 102 -
Summary of Contents for TX-58DXW804
