Panasonic TX-25LK10C, Operating Instructions Manual

Page: 27 / 28

27
H
Service
Before requesting service, please refer to the troubleshooting
guide on previous page to determine the symptoms. To obtain
service please contact your local Panasonic dealer quoting the
model number and serial number (both are located at the rear of
the TV).
H
TV Games / Home Computers
Extended use of TV games or home computerswith any television
set can cause a permanent ‘shadow’ on the screen. This type of
irreversible picture tube damage, can be limited by observing the
following points:
D
Reduce the brightness and contrast levels to a minimum
viewing level.
D
Do not operate the television set for a continuous period of
time while using TV games or home computers.
D
This type of picture tube damage, is not an operating
defect, and as such is not covered by the Panasonic
warranty.
H
Last Position Memory
Certain functions have a last position memory, i.e. the setting at
the time of switch
--
off will be the setting used when the receiver is
switched on again:
--
Programme Tint (M.NTSC / NTSC only)
OSD language Decoder (AV2)
AV Position Contrast
Volume Sharpness
MPX Aspect
Bass Standby
Treble Artificial Intelligence (AI) --- Picture
Balance Colour
Colour Balance Brightness
Status Ambience
P -- NR Teletext mode
Volume correction Q
--
Link
H
Sleep Feature
If the set is notswitched off when the TV station stops transmitting ,
it will automatically go to standby mode after 30 minutes. This
function will not operate when the TV is in AV mode.
TX
--
28LK10C TX
--
25LK10C
Power Source
220 -- 240V 50Hz A.C.
Power Consumption 121W 103W
Standby Consumption
1,4W
Picture Tube
Visible Diagonal
66 cm 59 cm
Audio Output
Music Power
2 x 7W RMS (2 x 15W MPO), 8
Ω
impedance
Dimensions
H
W
D
575 mm
775 mm
460 mm
525 mm
717 mm
466 mm
Weight 32,5 kg 26 kg
Receiving
Systems/
PAL B/G, H, SECAM B/G
VHF E2 -- E12 VHF H1 -- H2 (ITALY)
VHF A -- H (ITALY) UHF E21 -- E69
CATV (S01 -- S05) CATV S1 -- S10 (M1 -- M10)
CATV S11 -- S20 (U1 -- U10) CATV S21 -- S41 (Hyperband)
PAL D/K SECAM D/K Systems/
Band name
PAL D/K, SECAM D/K
VHF R1
--
R2 VHF R3
--
R5
VHF R6
--
R12 UHF E21
--
E69
PAL 525/60 Playback of NTSC tape from some PAL video recorders (VCR)
M.NTSC (AV input only) Playback from NTSC 4,43 MHz Videorecorders (VCR)
NTSC (AV input only) Playback from NTSC Videorecorders (VCR)
Number of programme positions
99 + VCR
Aerial
--
Rear UHF / VHF
Headphones
--
Front 3,5mm, 8
Ω
impedance
AV
--
Rear
AV1
--
21 pin terminal
--
Audio / Video in / out, RGB in.
AV2
-- 21 pin terminal -- Audio / Video in/out, S -- Video in, Q -- Link
2 x RCA Audio Monitor Out.
AV -- Front AV3 -- 2 x RCA Audio in, 1 x RCA Video in.
Specifications are subject to change without notice. Weight and dimensions shown are approximate.
FOR YOUR GUIDANCE
SPECIFICATIONS