19
English
Retuning from Setup
Menu
Automatically retunes the channels received in the area.
●
This function is available if channel tuning is already
performed.
●
Only the selected mode is retuned. All the previous
tuning settings are erased.
●
Child Lock PIN number is required to retune locked
channels.
1
Display the menu and select
[Settings]
select
access
2
Select [Antenna/cable installation]
select
access
3
Select the item and press OK to
access
select
access
Start the Installation
■
Update Channels
1
Select [Update channels].
select
access
You can always start a channel update manually, new
channels will be added, and unavailable channels will
be removed.
Automatically Search for Channels
1
Select [Automatic channel update].
●
If you receive digital channels, you can set the TV to
automatically update the list with new channels.
●
New channels are stored in the All channels list and
New channels list. Empty channels are removed.
●
If new channels are found or if channels are updated
or removed, a message is shown at TV start up.
The TV must be in standby to automatically update
channels.
Channel Update Messages
When new channels are found or if channels are
updated or removed, a message is shown at TV start up.
To avoid this message to appear after every channel
update, you can switch it off.
DVB-C, DVB-T, Analogue
Re-install Channels
1
Select [Antenna/cable installation] > [Search for
channels].
2
Select [Re-install channels].
3
Select the country and press OK.
4
Select [Antenna (DVB-T)] or [Cable (DVB-C)], and
select one item you need to re-install.
5
Select [Digital and analogue channels], [Only digital
channels], or [Only analogue channels].
6
Select [Start] and press OK to update channels. This
can take a few minutes..
Reception test
The digital frequency is shown for the channel. If the
reception is poor, check and reposition your antenna.
Check the signal quality, select [Search].
If you use DVB-C to receive channels, the option
[Symbol rate mode] is available. For Symbol rate mode,
select [Automatic], unless your cable provider gave
you a specific symbol rate value. To enter the specific
symbol rate value, select [Symbol rate], and type in the
value.
Manual Installation
Manually install analogue TV channel if needed.
1
Select [Antenna/cable installation] > [Analogue:
Manual Installation].
■
System
Set up the TV system and select the country.
■
Search Channel
Enter a frequency to find a channel. The found
channel is shown and if the reception is poor, press
[Search] again. Select [Done] and press OK to store
the channel.
■
Fine tune
Select [Fine tune] to fine tune a channel.
■
Store
You can store the channel on the current channel
number or as a new channel number.
Select [Store] and press OK. The new channel
number is shown briefly.
