17
Dual Touch
Do not apply excessive force to the screen
Do not lift the computer while holding the LCD screen, or allow the screen to be twisted. Do not place any objects on the
LCD screen. Any of the above may cause the screen glass to break, or may damage the LCD screen.
If the cursor jumps to a location other than where the screen was touched, or if
the LCD resolution changes, recalibrate the touchscreen
Perform the procedure of “Dual Touch Calibration” (below).
NOTE
Perform these calibration for each user.
If you cannot touch the desired position, perform Digitizer Calibration again and restart the computer.
Digitizer Calibration
1
Run [Calibration Utility].
Click
(Start)
- [All Programs] - [Panasonic] - [Calibration Utility].
2
Select [Pen input (Digitizer)].
To calibrate more accurate, add a check mark for [Advanced calibration].
3
Using your finger, touch each of the “+” target marks one by one.
Perform the calibration for the orientation to be used.
Things to keep in mind when using the dual touch
Dual Touch Calibration