Operation
28
Operating with the touch sensors
You can operate the touch sensors on the earphones to change to the Bluetooth
®
pairing mode, or remote
control the Bluetooth
®
device.
• Depending on the Bluetooth
®
device or the app, even if you operate the touch sensors on the earphones, some
functions may not respond or may operate differently from the descriptions below.
∫
List of operations available with the touch sensors
*1 To cancel muting, touch the touch sensor (R) twice again while muting.
*2 With both earphone LEDs (L and R) blinking alternately in blue and red
Note
• You can change the functions assigned to the touch sensors on the “Technics Audio Connect” app (free of charge).
(Customization of touch sensor) (
• You can also use just one side of the earphones independently. In this case, it is only possible to perform operations
available on the side you are using.
• A beep sounds to indicate that you have touched to reach either the maximum or minimum volume level.
Function
Touch sensor (L)
Touch sensor (R)
Listening to music
Playback/pause
Touch once
Raise the volume
Touch rapidly 3 times
–
Lower the volume
Touch rapidly 2 times
–
Forward a track
–
Touch rapidly 2 times
Back a track
–
Touch rapidly 3 times
Making a phone call
Receive a phone call
Touch once while receiving the call
Raise the volume
Touch rapidly 3 times
–
Lower the volume
Touch rapidly 2 times
–
Mute the voice of the call
*1
–
Touch rapidly 2 times during the
call
Switch the noise level heard
from the other party
–
Touch rapidly 3 times during the
call
Reject a phone call
Touch and hold for about 2 seconds while receiving the call
End a phone call
Touch and hold for about 2 seconds during the call
Change control of external
sounds
–
Touch and hold for about
2 seconds
Start the voice assistant
Touch and hold for about
2 seconds
–
Set to the Bluetooth
®
pairing
mode
*2
Return to the factory settings
29, “Restoring to the factory settings”)
eah̲az60̲az40̲pnqp1654ya̲full̲eng̲s.book 28 ページ ２０２１年１２月２１日 火曜日 午後５時１８分
