Antenna / Cable service without a box
Initial setting
●
Depending on the model, it may be necessary to remove the terminal
cover / cable cover before connecting or disconnecting cables.
1. Connect coax
Connect a COAX wire from either an Antenna or Basic Cable service to
the TV’s “ANTENNA/CABLE IN” screw terminal.
TV (ANTENNA/CABLE IN)
Antenna
2. Scan the channel
MENU
Menu
>
Setup
>
ANTENNA/Cable setup
>
ANTENNA/
Cable signal
,
Auto program
1) Select either Cable or Antenna programming source in
ANTENNA/
Cable signal
.
2) Select
Auto program
and then the appropriate scan mode:
(
All channels
/
Analog only
/
Digital only
)
3) Start scanning.
●
The tuner setup menu (auto scan, etc.) is only available when INPUT is
set to TV.
●
If no channels are found by the end of the scan, then check the
following:
– Antenna’s position - or availability of Cable service.
– Cable, Satellite or Fiber Optic services with a box are typically
connected to the TV’s A/V inputs, preferably HDMI, for best HD
picture. In such case, the channel scanning is not needed.
- 28 -
