Panasonic SF4D Series, Instruction Manual

Page: 29 / 176

Mounting
© Panasonic Industrial Devices SUNX Co., Ltd. 2017 29
2-4-1-1 Using Beam Adjustment Mounting Bracket MS-SFD-1-□ (Option)
Step 1 Insert the mounting plate of the base bracket into the base bracket mounting rail on the
back of the device.
Base bracket
Mounting plate
This device
Base bracket mounting rail
Step 2 With the base bracket in firm contact with the device, tighten the two ultra low-head hex
socket bolts [M5 (length 5mm), opposing faces 3mm] that fasten the base bracket.
Tighten to a torque of 3N·m or less.
Ultra low-head hex socket bolt for base
bracket
[M5 (length 5mm), opposing faces 3mm]
No gap between base
bracket and device.
<Side mounting>
Loosen the two hexagon-socket head bolts with washers [M4 (length 8mm), opposing
faces 3mm] and remove the bracket.
Change the orientation of the mounting bracket, and tighten the two hexagon-socket
head bolts with washers [M4 (length 8mm), opposing faces 3mm]. Tighten to a torque
of 1.5N·m or less.
Hexagon-socket head bolt with washer
[M4 (length 8mm), opposing faces 3mm]
(Included with MS-SFD-1-□ )
Base bracket
Mounting bracket