Panasonic SC-HG1-C, User Manual, Page: 15 / 128

Before Using This Product
WUME-SCHG1C-4 1-7
1-5 Description of parts
1 2 3
4 5 7 6 8
10
9
11
<Switch cover removed>
Name Function
1
Station number setting
switch
Set the CC-Link station number to a value from 1 to 64.
(Do not set to 0, or 65 or higher.)
[Factory default state: 1]
2
Communication speed
setting switch
Set the CC-Link communication speed.
0: 156 kbps, 1: 625 kbps, 2: 2.5 Mbps, 3: 5 Mbps, 4: 10 Mbps
[Factory default state: 156 kbps]
3 CC-Link connector Connect to the master station or another slave station.
4 Male connector Connect to a master controller or slave controller.
5 ERR. indicator (Red)
Lights up when CC-Link communication is interrupted. Blinks when a communi-
cation error occurs.
6
Power indicator (Green) Lights up when power is supplied.
7
RD indicator (Green) Lights up during data reception.
8
L RUN indicator (Green) Lights up during data link execution.
9
SD indicator (Green) Lights up during data sending.
10
L ERR. indicator (Red)
Lights up if the station number setting switch and communication speed setting
switch are in an invalid setting position when the power is turned on.
Blinks if the switch type setting is changed while the power is on.
11 Mode setting switch
Set the communication method and number of occupied stations.
[Factory default state: CC-Link mode 1]
• CC-Link mode 1
SW No. 1 2 3 4 5 6 7 8
ON / OFF ON OFF Not used (Note)
Remarks CC-Link Ver. 1.10, number of occupied stations: 4
• CC-Link mode 2
SW No. 1 2 3 4 5 6 7 8
ON / OFF OFF ON Not used (Note)
Remarks
CC-Link Ver.2.00, Number of occupied stations: 2
stations
Expanded cyclic transmission speed: x8
• CC-Link mode 3
SW No. 1 2 3 4 5 6 7 8
ON / OFF ON ON Not used (Note)
Remarks
CC-Link Ver.2.00, Number of occupied stations: 4
stations
Expanded cyclic transmission speed: x4
Note: Always keep unused switches in the OFF position.