25
8.11. Disassembly of Motor P.C.B.
• Refer to “Disassembly of Front Ornament Unit (L) & (R)”
• Refer to “Disassembly of Front Panel Block”
Step 1 :
Release 5P wire from slots.
Step 2 :
Remove screw.
Step 3 :
Remove screw.
Step 4 :
Lift up Motor P.C.B..
Caution : During assembly, avoid using electric screw-
driver to prevent overrun for [
] type screw.
Step 5 :
Detach 5P wire at connector (CN931) on Motor P.C.B..
Step 6 :
Desolder pins on solder side of Motor P.C.B..
Step 7 :
Remove Motor P.C.B..
8.12. Disassembly of Gear Block &
Arm Spring (Top)
• Refer to “Disassembly of Front Ornament Unit (L) & (R)”
• Refer to “Disassembly of Door Unit”
• Refer to “Disassembly of Front Panel Block”
Step 1 :
Push up to release Door Holder as arrow shown.
Caution : During assembly, ensure Door Holder is lock as
shown.
Step 2 :
Release 5P wire from slots.
Step 3 :
Detach 5P wire at connector (P942) on Bridge P.C.B..
Summary of Contents for SC-HC395EG
