Panasonic SC-CMAX5GS, Service Manual

Page: 26 / 92

26
8.6. Disassembly of Amp Unit
Block
• Refer to “Disassembly of Handle Bar Unit”
• Refer to “Disassembly of Rear Panel”
Step 1 : Detach 4P wire at connector (CN2508) on Main P.C.B.
Assembly.
Step 2 : Detach 30P FFC at connector (CN2506) on Main
P.C.B. Assembly.
Step 3 : Detach 10P wire at connector (CN2511) on Main
P.C.B. Assembly.
Step 4 : Detach 4P wire at connector (CN2510) on Main P.C.B.
Assembly.
Step 5 : Detach 6P wire at connector (CN2507) on Main P.C.B.
Assembly.
Step 6 : Detach grounding wires.
Step 7 : Slightly lift up Amp Unit Block.
Caution : Do not exert strong force as it may damage the
wiring within.
Step 8 : Place Amp Unit Block on the support block.
Step 9 : Cut the cable tie.
Step 10 : Detach 4P wire at connector (CN2604) on Main
P.C.B. Assembly.
Step 11 : Detach 2P wire at connector (JK3503) on Main P.C.B.
Assembly.
Step 12 : Detach 4P wire at connector (JK3502) on Main P.C.B.
Assembly.
Step 13 : Remove Amp Unit Block.