14
3.8.
Replacement of Speaker Connector Housing (For SB-MAX700PHK)
3.8.1.
Disassembly of Speaker Connector Housing
Step 1:
Insert a paper clip & push the Wire terminals outwards.
Step 2:
Detach the (+) and (-) speaker wire.
3.8.2.
Assembly of Speaker Connector
Housing
Step 1:
Slightly lift up the wire terminals approximately 45
°
as
shown.
Step 2:
Insert the (+) speaker wire into the (+) hole of the
Speaker Connector Housing.
Step 3:
Push in the speaker wire until hear the “click” sound.
Step 4:
Insert the (-) speaker wire into the (-) hole of the
speaker connector housing.
Step 5:
Push in the speaker wire until hear the “click” sound.
Step 6:
Pull both speaker wires gently to ensure they lock-in
firmly.
Note:
Repeat these procedures if the speaker wires come out.
