Panasonic S-LINK V, User Manual

Page: 70 / 182

70
Chapter 3
Starting
Check of Recognized Addresses
Set the mode selector switch to CHECK. In the CHECK mode, the number of connected PLC I/O connectors,
number of connected nodes (number of connected I/O units), and recognized addresses will be displayed.
CHECK mode
Operation Description / Function
Decimal number
display
Hexadecimal
number display
Set the mode selection switch
to CHECK.
Displays the number of recognized PLC I/O connectors.
Press key.
Displays the number of recognized nodes (number of I/O units
connected to the controller.)
Press key.
Press key.
Repeatedly press this key to
display all the connected con-
necotrs
Displays the recognized PLC I/O connector numbers from the
smallest number to the largest number.
： ：
Press key.
Press key.
Repeatedly press this key to
display all the connected con-
necotrs
Displays the recognized I/O connector address numbers from the
smallest number to the largest number.
： ：
Notes: 1) Use key to display the numbers in the reversed order.
2) Press and hold SELECT key ( key or key) to switch the displayed numbers at a high speed.
3) If the unit is the I/O mixed type, only the input addresses will appear.
Example: In the decimal number display
Number of PLC
I/O connectors
Recognized I/O unit addresses
Recognized PLC I/O
connector numbers
Number of connected nodes
(connected I/O units)
* A recognized address means the first digit of a unit address (address set by the address setting switch).