RQT9485
16
Troubleshooting guide
Before requesting service, make the following checks. If you are in doubt about any of the check points, or if the solutions
indicated in the chart do not solve the problem, consult your dealer for instructions.
Problem
Probable cause(s)
Suggested remedy
Page
No sound.
Is the unit that the transmitter is
connected to on?
Turn the unit on.
12
Are the unit and the transmitter
connected?
Connect the unit correctly and ensure the
plugs are properly inserted.
10
Is the volume too low?
If the transmitter is connected to the
headphone jack, turn up the volume of the
connected unit.
12
Turn up the volume on the headphones.
12
Sound is distorted.
Is the input level of the audio signal
too high?
If the transmitter is connected to the
headphone jack, turn down the volume of
the connected unit.
12
Excessive noise.
Is there an obstruction between the
transmitter and the headphones?
Remove the obstruction, move the
transmitter, or change position yourself.
10
●
Are other radio waves obstructing
the transmitter’s waves?
●
Are the transmission frequency
and the receiver’s frequency
tuned correctly?
Change the transmitter channel using the
[CHANNEL] switch, and then press the
[TUNING] button on the headphones to
adjust the frequency automatically.
14
Is the input level of the audio signal
too low?
If the transmitter is connected to the
headphone jack, turn up the volume of the
connected unit.
12
No sound, sound is
distorted, or there is
excessive noise.
Is the OPR indicator dim or does it
fail to light at all?
The batteries have run down. Recharge
them. If the indicator remains dim after
recharging, the batteries have come to the
end of their serviceable life and need to be
replaced.
8
Declaration of Conformity (DoC)
Hereby, “Panasonic Corporation” declares that this product is in compliance with the essential requirements
and other relevant provisions of Directive 1999/5/EC.
Customers can download a copy of the original DoC to our R&TTE products from our DoC server:
http://www.doc.panasonic.de
Contact to Authorised Representative: Panasonic Marketing Europe GmbH, Panasonic Testing Centre,
Winsbergring 15, 22525 Hamburg, Germany
This product is intended to be used in the following countries.
The UK, FRANCE, GERMANY, ITALY, SWITZERLAND, AUSTRIA, NETHERLANDS, BELGIUM, SPAIN,
SWEDEN, NORWAY, DENMARK, FINLAND, HUNGARY, CZECH REPUBLIC, SLOVAKIA, SLOVENIA,
BULGARIA, POLAND
This product is intended for general consumer. (Category 3)
ENGLISH
