Preparation
9
Charging
The rechargeable battery (installed in the unit) is not charged initially. Charge the battery before using the unit.
Connect this unit to a computer using the
USB charging cord.
• The power/pairing LED lights in red when charging is in
progress. When charging is completed, the power/
pairing LED will go out.
• It takes approx. 5 hours to charge the battery from
empty to full.
Note
• Charge in a room temperature between 10
o
C and 35
o
C (50
o
F and 95
o
F). Outside of this temperature range,
charging may stop and the power/pairing LED may go out.
• It is not possible to turn the power on or connect to Bluetooth
®
devices during charging.
• Do not use any other USB charging cords except the supplied one. Doing so may cause malfunction.
• Charging may not be performed or may stop if the computer is in or switched to standby or sleep mode.
Turning the power on/off
In the power-off state, press and hold [
Í
/I ( )] of this unit
for approx. 3 seconds until the power/pairing LED (blue)
blinks.
• A beep will sound, and the power/pairing LED (blue) will blink slowly.
∫
To turn the power off
Press and hold [
Í
/I ( )] for approximately 3 seconds. An English
guidance message will be heard, and the power will be turned off.
• It is possible to switch the audio guidance between English and French.
Note
• If the unit is not connected to a Bluetooth
®
device, an English guidance message will be heard and turn off the unit
automatically approximately 5 minutes after you have stopped using it. (
• It is possible to switch the audio guidance between English and French. (
A
: Power/pairing LED
B
: USB charging cord (supplied)
• Check the direction of the terminals and plug in/out
straight holding onto the plug. (It may result in
malfunction by the deforming of the terminal if it is
plugged in obliquely or in wrong direction.)
C
: Computer
• Turn on the computer in advance.
A
B
C
Right (R)
side
Power/pairing
LED
[
Í
/I (
)]
Right (R) side
